Home › BRAKE › BRAKE › BRAKE PEDAL (w/o VSC)

BRAKE PEDAL (w/o VSC) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE COMBINATION METER ASSEMBLY
  1. Remove the combination meter (Click here).



3. DISCONNECT BRAKE MASTER CYLINDER PUSH ROD CLEVIS
  1. Disconnect the stop light switch connector.



    C226773E01
  1. Remove the return spring.

  1. Remove the clip and clevis pin.

  1. Disconnect the push rod clevis from the brake pedal.



4. REMOVE BRAKE PEDAL SUPPORT SUB-ASSEMBLY


    C226772
  1. for 1KD-FTV with Manual Transmission:
    Detach the connector clamp and clamp from the brake pedal support sub-assembly.



    C228311E01
  1. Remove the bolt from the support.



    C111300
  1. Remove the 4 nuts and support.