BRAKE BOOSTER > REMOVAL |
| 1. DRAIN BRAKE FLUID |
| 2. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY (w/o ABS) |
![]() |
for Manual Transmission:
Disconnect the clutch reservoir tube labeled A from the master cylinder.
Disconnect the brake fluid warning switch connector labeled B.
Using a union nut wrench, disconnect the 6 brake lines labeled C from the master cylinder and 4-way.
![]() |
Remove the 2 nuts and bracket (with 4-way).
Pull out the master cylinder from the brake booster.
Remove the O-ring from the master cylinder.
| 3. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY (w/ ABS) |
![]() |
for Manual Transmission:
Disconnect the clutch reservoir tube labeled A from the master cylinder.
Disconnect the brake fluid level warning switch connector labeled B.
Using a union nut wrench, disconnect the 5 brake lines labeled C from the master cylinder and 3-way.
![]() |
Remove the 2 nuts and bracket (with 3-way).
Pull out the master cylinder from the brake booster.
Remove the O-ring from the master cylinder.
| 4. REMOVE BRAKE BOOSTER ASSEMBLY |
Disconnect the vacuum warning switch connector and remove the vacuum warning switch from the booster.
Disconnect the vacuum hose.
Remove the check valve and grommet from the booster.
![]() |
Remove the return spring, clip and clevis pin.
Loosen the push rod clevis lock nut.
![]() |
Remove the 4 nuts and push rod clevis.
Pull out the booster and gasket.