Home › BRAKE › BRAKE › FRONT BRAKE (for TSAM Made)

FRONT BRAKE (for TSAM Made) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.



1. REMOVE FRONT WHEEL


2. DRAIN BRAKE FLUID

NOTICE:
Wash off brake fluid immediately if it comes in contact with any painted surface.



3. REMOVE FRONT DISC BRAKE ANTI-RATTLE SPRING


F043185E02
  1. Remove the 2 clips. Then remove the 2 pins.

  1. Remove the spring.

    NOTICE:
    The anti-rattle spring can be reused if it has sufficient rebound; no deformation, cracks or wear; and has all rust, dirt and foreign matter cleaned off.



4. REMOVE FRONT DISC BRAKE PAD
  1. Remove the 2 disc brake pads.



5. REMOVE FRONT ANTI-SQUEAL SHIM KIT
  1. Remove the No.1 and No. 2 shims from each pad.



6. DISCONNECT FRONT NO. 1 WHEEL CYLINDER TUBE LH


F043120
  1. Using a union nut wrench, disconnect the tube from the cylinder.



7. REMOVE DISC BRAKE CYLINDER ASSEMBLY LH


C111377
  1. Remove the 2 bolts and cylinder.