Home › BRAKE › BRAKE › FRONT BRAKE (for TMT Made)

FRONT BRAKE (for TMT Made) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.



1. REMOVE FRONT WHEEL


2. DRAIN BRAKE FLUID

NOTICE:
Wash off brake fluid immediately if it comes in contact with any painted surface.



3. REMOVE FRONT DISC BRAKE ANTI-RATTLE SPRING


  1. for 15 inch Front Disc Brake:



      C215909E01
    1. Remove the pin hold clip and 2 disc brake pad guide pins.

    2. Remove the anti-rattle spring.

      NOTICE:
      The anti-rattle spring can be reused if has sufficient rebound; no deformation, cracks or wear; and has all rust, dirt and foreign matter cleaned off.



  1. for 16 inch Front Disc Brake:



      F043185E02
    1. Remove the 2 clips. Then remove the 2 pins.

    2. Remove the spring.

      NOTICE:
      The anti-rattle spring can be reused if it has sufficient rebound; no deformation, cracks or wear; and has all rust, dirt and foreign matter cleaned off.



4. REMOVE FRONT DISC BRAKE PAD
  1. Remove the 2 disc brake pads.



5. REMOVE FRONT ANTI-SQUEAL SHIM KIT
  1. Remove the No.1 and No. 2 shims from each pad.



6. DISCONNECT FRONT NO. 1 WHEEL CYLINDER TUBE LH


F043120
  1. Using a union nut wrench, disconnect the tube from the cylinder.



7. REMOVE DISC BRAKE CYLINDER ASSEMBLY LH


C111377
  1. Remove the 2 bolts and cylinder.