Home › BRAKE › BRAKE › FRONT BRAKE (for TMT Made)

FRONT BRAKE (for TMT Made) > DISASSEMBLY

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.



1. REMOVE CYLINDER BOOT


F043024
  1. Using a screwdriver, remove the 4 set rings and 4 boots from the cylinder.

    HINT:
    tape the screwdriver tip before use.

    NOTICE:
    Be careful not to damage the inner cylinder and cylinder groove.



2. REMOVE FRONT DISC BRAKE PISTON


C111364E02
  1. Prepare a wooden plate to hold the pistons.



    F042677
  1. Place the wooden plate between the pistons and insert a pad on one side.

  1. Use compressed air to remove the pistons one by one from the cylinder.

    CAUTION:
    Do not place your finger in front of the piston when using compressed air.

    NOTICE:
    Be careful not to spatter the brake fluid.



3. REMOVE PISTON SEAL


F042678
  1. Using a screwdriver, remove the 4 seals from the cylinder.

    HINT:
    Tape the screwdriver tip before use.

    NOTICE:
    Be careful not to damage the inner cylinder and cylinder groove.



4. REMOVE FRONT DISC BRAKE BLEEDER PLUG
  1. Remove the bleeder plug cap and bleeder plug from the cylinder.



5. REMOVE FRONT DISC


C111383E01
  1. Put matchmarks on the disc and axle hub.

  1. Remove the disc.