Home › BRAKE › BRAKE › BRAKE MASTER CYLINDER (w/ VSC)

BRAKE MASTER CYLINDER (w/ VSC) > REMOVAL

for Preparation Click here


NOTICE:
Make sure to release the vacuum from the brake booster before removing the master cylinder from the brake booster.



1. DRAIN BRAKE FLUID

NOTICE:
Wash off brake fluid immediately if it comes in contact with any painted surface.



2. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY
  1. for Manual Transmission:
    Disconnect the clutch reservoir tube from the brake master cylinder reservoir.



    C247710
  1. Disconnect the brake fluid level warning switch connector.

  1. Using a union nut wrench, disconnect the 4 brake lines from the brake master cylinder and brake tube way.



    C247711
  1. Remove the 2 nuts and brake tube way.

  1. Pull out the brake master cylinder from the brake booster.

  1. Remove the O-ring from the brake master cylinder.