Home › BRAKE › BRAKE › BRAKE MASTER CYLINDER (for TMT Made)

BRAKE MASTER CYLINDER (for TMT Made) > REMOVAL

for Preparation Click here


NOTICE:
Make sure to release the vacuum from the brake booster before removing the master cylinder from the brake booster.



1. DRAIN BRAKE FLUID

NOTICE:
Wash off brake fluid immediately if it comes in contact with any painted surface.



2. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY


    C165330
  1. Disconnect the brake fluid level warning switch connector.

  1. Using a union nut wrench, disconnect the 5 brake lines from the master cylinder and 3-way.



    C165331
  1. Remove the 2 nuts and bracket (with 3-way).

  1. Pull out the master cylinder from the brake booster.

  1. Remove the O-ring from the master cylinder.