EMISSION CONTROL SYSTEM (w/ Secondary Air Injection System) > ON-VEHICLE INSPECTION |
| 1. CHECK FOR LEAKS |
![]() |
Visually check that the hoses, connections and gaskets have no cracks, leaks or damage.
| 2. CHECK PURGE VSV |
![]() |
Check that the vacuum hose is connected correctly.
Disconnect the vacuum hose from the canister, and connect a vacuum gauge.
Using the flowchart below, perform a purge VSV operation inspection when the engine coolant temperature is 55°C (131°F) or less (while the engine is cold (purge VSV is closed)).
Purge VSV operation flowchart.
| Result | Procedure |
| Yes | Purge VSV operation normal |
| No | Go to next step |
| Result | Procedure |
| OK | Check wire harness and ECM |
| NG | Replace purge VSV |
Using the flowchart below, perform a purge VSV operation inspection when the engine coolant temperature is 80°C (146°F) or more (while the engine is hot (purge VSV is opened)).
Purge VSV operation flowchart.
| Result | Procedure |
| Yes | Purge VSV operation normal |
| No | Go to next step |
| Result | Procedure |
| OK | Check wire harness and ECM |
| NG | Replace purge VSV |