DTC P0335 Crankshaft Position Sensor "A" Circuit |
DTC P0339 Crankshaft Position Sensor "A" Circuit Intermittent |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0335 | When either of the following conditions is met (1 trip detection logic):
|
|
| P0339 | Conditions (a), (b) and (c) are met, and no crankshaft position sensor signal to ECM for 0.05 seconds or more. (1 trip detection logic) (a) Engine revolution 1,000 rpm or more (b) Starter signal is OFF (c) 3 seconds or more have elapsed after starter signal was switched from ON to OFF |
|

| 1.INSPECT CRANK SHAFT POSITION SENSOR (RESISTANCE) |
![]() |
Disconnect the C5 sensor connector.
Measure the resistance of the sensor.
| Tester Connection | Sensor Condition | Specified Condition |
| 1 - 2 | Cold | 1,630 to 2,740 Ω |
| 1 - 2 | Hot | 2,065 to 3,225 Ω |
|
| ||||
| OK | |
| 2.CHECK WIRE HARNESS (CRANKSHAFT POSITION SENSOR - ECM) |
![]() |
Disconnect the C5 sensor connector.
Disconnect the E11 ECM connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| C5-1 - E11-27 (NE+) | Below 1 Ω |
| C5-2 - E11-34 (NE-) | Below 1 Ω |
| C5-1 or E11-27 (NE+) - Body ground | 10 kΩ or higher |
| C5-2 or E11-34 (NE-) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK CRANKSHAFT POSITION SENSOR (INSTALLATION) |
![]() |
Check that the crankshaft position sensor is installed correctly.
|
| ||||
| OK | |
| 4.CHECK NO. 2 CRANKSHAFT TIMING SPROCKET (TEETH OF SENSOR PLATE) |
Check that the teeth of the sensor plate do not have any cracks or deformation.
|
| ||||
| OK | ||
| ||