Home › ENGINE ยท 2TR-FE › ENGINE CONTROL SYSTEM › SFI SYSTEM (w/ Secondary Air Injection System)

DTC    P0016    Crankshaft Position - Camshaft Position Correlation (Bank 1 Sensor A)

for Preparation Click here


DESCRIPTION

Refer to DTCs P0335 and P0339 .

DTC No.
DTC Detection Condition
Trouble Area
P0016
Deviation in crankshaft position sensor signal and camshaft position signal (2 trip detection logic)
  1. Mechanical system (jumped tooth of timing chain or chain stretched)
  2. ECM

MONITOR DESCRIPTION

The ECM optimizes the valve timing using the VVT system to control the intake valve camshaft. The VVT system includes the ECM, Oil Control Valve (OCV) and VVT controller. The ECM sends a target duty-cycle control signal to the OCV. This control signal, applied to the OCV, regulates the oil pressure supplied to the VVT controller. The VVT controller can advance or retard the intake valve camshaft. The ECM calibrates the valve timing of the VVT system by setting the camshaft to the maximum retard angle when the engine is idling. The ECM closes the OCV to retard the cam. The ECM stores this value as VVT learned value. When the difference between the target valve timing and actual valve timing is more than 5°Crankshaft Angle (CA), the ECM learns it.
If the learned value meets conditions (a) and (b) below, the ECM interprets this as a defect in the VVT system and sets a DTC.
(a) VVT learning value is less than 20°CA or more than 39°CA.
(b) Above condition continues for 18 seconds or more.
This DTC shows that the camshaft was installed toward the crankshaft at an incorrect angle (for example: jumped tooth of timing belt).
This monitor runs after the engine is idling for 5 minutes.

WIRING DIAGRAM

Refer to DTCs P0335 and P0339 .

INSPECTION PROCEDURE

HINT:
Read freeze frame data using the intelligent tester. Freeze frame data records the engine conditions when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.

1.CHECK VALVE TIMING (FOR LOOSENESS AND A JUMPED TOOTH OF TIMING CHAIN)


    G038864E01
  1. Remove the cylinder head cover.

  1. Turn the crankshaft to align the timing marks of the crankshaft.

  1. Align the groove of the crankshaft pulley with the "0" position.

  1. Confirm whether the timing marks of the camshaft pulley and cylinder head cover are facing each other.

  1. If the timing marks are not facing each other, turn the crankshaft clockwise 360°. Confirm again if the timing marks are facing each other.

    OK:
    The timing marks of the camshaft pulley and the cylinder head cover face each other when the groove of the crankshaft pulley is in the "0" position.



NG
ADJUST VALVE TIMING (REPAIR OR REPLACE TIMING CHAIN)
OK

REPLACE ECM