Home › ENGINE ยท 1KD-FTV › ENGINE CONTROL SYSTEM › ECD SYSTEM (for i-ART)

DTC    P168A    Injector #1 Internal EEPROM Malfunction

DTC    P168B    Injector #2 Internal EEPROM Malfunction

DTC    P168C    Injector #3 Internal EEPROM Malfunction

DTC    P168D    Injector #4 Internal EEPROM Malfunction

for Preparation Click here


DESCRIPTION


P168A, P168B, P168C, P168D 
DTC Detection Drive Pattern
DTC Detection Condition
Trouble Area
Ignition switch ON for 3 minutes or more
The EEPROM in the injector assembly is malfunctioning (EEPROM access (write or read) cannot be performed) for 3 seconds or more.
(1 trip detection logic)
  1. No. 1 injector assembly
  2. No. 2 injector assembly
  3. No. 3 injector assembly
  4. No. 4 injector assembly

WIRING DIAGRAM

Refer to DTC P0201 .

INSPECTION PROCEDURE

HINT:
  1. Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.

1.CHECK FOR DTCS OUTPUT
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON and GTS on.

  1. Clear the DTCs (Click here).

  1. Turn the ignition switch off and wait for 30 seconds or more.

  1. Turn the ignition switch to ON for 3 minutes or more.

  1. Enter the following menus: Powertrain / Engine / Trouble Codes.

  1. Read the DTCs.

    Result 
    Result
    Proceed to
    DTC P168A, P168B, P168C and/or P168D is output
    A
    No DTC is output
    B



B
CHECK FOR INTERMITTENT PROBLEMS (Click here)
A


2.REPLACE INJECTOR ASSEMBLY (RELEVANT CYLINDER)
  1. Replace the injector assembly of the cylinder relevant to the DTC (Click here).

    NOTICE:
    1. When replacing the injector assembly for a cylinder, always be sure to use a new injection pipe.
    2. Follow the procedure in the repair manual and temporarily install the injection pipes and nozzle leakage pipe, and then correctly position the injector assemblies. After that, tighten parts according to the torque specifications.
    3. If the installation procedure is not performed correctly, injector assemblies may become out of position, which may cause the injector assemblies to deteriorate, resulting in malfunctions.
    4. If an injector assembly deteriorates and malfunctions, other problems such as knocking, rough idle, etc. may occur.
    5. If an injector assembly becomes out of position, it is possible that the seal between the injector assembly and injection pipe may become incomplete, resulting in a fuel leak.


NEXT


3.BLEED AIR FROM FUEL SYSTEM
  1. Bleed the air from the fuel system .


NEXT


4.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON and turn the GTS on.

  1. Clear the DTC (Click here).

  1. Turn the ignition switch off and wait for 30 seconds or more.

  1. Turn the ignition switch to ON for 3 minutes or more.

  1. Enter the following menus: Powertrain / Engine / Trouble Codes.

  1. Confirm that the DTC is not output again.


NEXT

END