Home › ENGINE ยท 2TR-FE › STARTING › STARTER (for 1.6 kW Type)

STARTER (for 1.6 kW Type) > DISASSEMBLY

for Preparation Click here



1. REMOVE REPAIR SERVICE STARTER KIT


    G037244
  1. Remove the nut and disconnect the lead wire from the repair service starter kit.



    G037245
  1. Remove the 2 screws holding the repair service starter kit to the starter drive housing.

  1. Remove the repair service starter kit.



2. REMOVE STARTER YOKE ASSEMBLY


    G037246
  1. Remove the 2 bolts, and pull out the starter yoke assembly together with the starter commutator end frame.



3. REMOVE STARTER COMMUTATOR END FRAME ASSEMBLY


    A083800
  1. Remove the starter commutator end frame from the starter yoke.



4. REMOVE STARTER ARMATURE PLATE


    A083803
  1. Remove the starter armature plate from the starter yoke.



5. REMOVE STARTER COMMUTATOR END FRAME COVER


    A083801
  1. Using a screwdriver, remove the starter commutator end frame cover.



6. REMOVE STARTER ARMATURE ASSEMBLY


    A073993E03
  1. Using snap ring pliers, remove the snap ring and plate washer.

  1. Remove the starter armature from the commutator end frame.



7. REMOVE PLANETARY GEAR


    G037248
  1. Remove the 3 planetary gears from the starter drive housing.



8. REMOVE STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY


    A073990
  1. Remove the starter center bearing clutch and starter drive lever set pin from the starter drive housing.

  1. Remove the starter drive lever set pin from the starter center bearing clutch.