Home › ENGINE ยท 2TR-FE › STARTING › STARTER (for 1.6 kW Type)

STARTER (for 1.6 kW Type) > REASSEMBLY

for Preparation Click here



1. INSTALL STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY


    A084665E01
  1. Install the drive lever set pin to the starter center bearing clutch sub-assembly.

  1. Install the starter center bearing clutch and drive lever set pin to the starter drive housing.



2. INSTALL PLANETARY GEAR


    G037248E01
  1. Apply grease to the planetary gears and pin parts of the planetary shaft.

  1. Install the 3 planetary gears into the pin of the planetary shaft.



3. INSTALL STARTER ARMATURE ASSEMBLY
  1. Apply grease to the plate washer, armature shaft and new snap ring.

  1. Install the starter armature and plate washer into the starter commutator end frame.



    A073993E03
  1. Using snap ring pliers, install the snap ring.

    NOTICE:
    1. Be sure to install the snap ring in the armature shaft groove securely.
    2. Be sure to properly install the snap ring because it easily expands.



    A058810E05
  1. Check the snap ring length.

    1. Using a vernier caliper, measure the snap ring length.

      Maximum length:
      5.0 mm (0.197 in.)

      If the length is greater than the maximum, replace the snap ring.



4. INSTALL STARTER COMMUTATOR END FRAME COVER


    A084616
  1. Install the commutator end frame cover into the starter commutator end frame.



5. INSTALL STARTER ARMATURE PLATE


    A073991E05
  1. Align the claw of the armature plate with the groove inside the starter yoke, and install the starter armature plate.



6. INSTALL STARTER COMMUTATOR END FRAME ASSEMBLY


    G037250E02
  1. Align the starter commutator end frame rubber with the groove of the starter yoke.

  1. Install the starter commutator end frame to the starter yoke.

    NOTICE:
    The magnet of the starter yoke may attract the starter armature when the starter commutator end frame is installed, causing the magnet break.



7. INSTALL STARTER YOKE ASSEMBLY


    G037251E02
  1. Align the claw of the starter yoke with the groove inside the starter drive housing.



    G037246
  1. Install the starter yoke with the 2 bolts.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }



8. INSTALL REPAIR SERVICE STARTER KIT
  1. Apply grease to the plunger and hook.



    G037613
  1. Hang the plunger hook of the repair service starter kit to the drive lever.



    G037245
  1. Install the repair service starter kit with the 2 screws.

    Torque:
    7.5 N*m{ 77 kgf*cm , 66 in.*lbf }



    G037244
  1. Connect the lead wire to the terminal with the nut.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }