Home › ENGINE · 2TR-FBE › CHARGING › GENERATOR

GENERATOR > INSPECTION

for Preparation Click here



1. INSPECT GENERATOR BRUSH HOLDER ASSEMBLY


    A118443E01
  1. Using a vernier caliper, measure the brush length.

    Standard length:
    9.5 to 11.5 mm (0.374 to 0.453 in.)

    Minimum length:
    4.5 mm (0.177 in.)

    If the brush length is less than the minimum, replace the generator brush holder assembly.



2. INSPECT GENERATOR ROTOR ASSEMBLY


    A118444
  1. Check that the bearing is not rough or worn, and that it rotates smoothly.
    If necessary, replace the generator rotor assembly.



  1. Check the resistance.



      A236749E01
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      Slip ring - Slip ring
      20°C (68°F)
      1.85 to 2.25 Ω

      If the result is not as specified, replace the generator rotor assembly.



    2. A236750E01
    3. Measure the resistance between the slip ring and rotor core.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      Slip ring - Rotor Core
      Always
      10 kΩ or higher

      If the result is not as specified, replace the generator rotor assembly.



  1. Check each slip ring.

    1. Check that the slip rings are not rough or scored.
      If rough or scored, replace the generator rotor assembly.



    2. A118447E03
    3. Using a vernier caliper, measure the slip ring diameter.

      Standard diameter:
      14.2 to 14.8 mm (0.559 to 0.583 in.)

      Minimum diameter:
      14.0 mm (0.551 in.)

      If the diameter is less than the minimum, replace the generator rotor assembly.