GENERATOR > INSPECTION |
| 1. INSPECT GENERATOR BRUSH HOLDER ASSEMBLY |
![]() |
Using a vernier caliper, measure the brush length.
| 2. INSPECT GENERATOR ROTOR ASSEMBLY |
![]() |
Check that the bearing is not rough or worn, and that it rotates smoothly.
If necessary, replace the rotor assembly.
![]() |
Check the resistance.
Measure the resistance between the slip rings.
![]() |
Measure the resistance between the slip ring and rotor core.
Check each slip ring.
Check that the slip rings are not rough or scored.
If rough or scored, replace the rotor assembly.
![]() |
Using a vernier caliper, measure the slip ring diameter.