GENERATOR > DISASSEMBLY |
| 1. REMOVE GENERATOR PULLEY |
![]() |
| Item | Part No. |
| SST 1-A and B | 09820-06010 |
| SST 2 | 09820-06021 |
Install SST 1-A and B to the generator rotor shaft.
Hold SST 1-A with a torque wrench, and tighten SST 1-B clockwise with the specified torque.
![]() |
Mount the generator in a vise between aluminum plate.
Insert SST 2 to attach it to pulley nut.
![]() |
To loosen the pulley nut, turn SST 1-A in the direction shown in the illustration.
Remove the generator from SST 2.
![]() |
Turn SST 1-A in the direction shown in the illustration, and remove SST 1-A and B.
Remove the pulley nut and pulley.
| 2. REMOVE GENERATOR REAR END COVER |
![]() |
Remove the 3 nuts and rear end cover.
| 3. REMOVE TERMINAL INSULATOR |
![]() |
Remove the terminal insulator.
| 4. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY |
![]() |
Remove the 2 screws and brush holder.
| 5. REMOVE GENERATOR COIL ASSEMBLY |
![]() |
Remove the 4 bolts.
![]() |
Using SST, remove the generator coil assembly.
| 6. REMOVE GENERATOR ROTOR ASSEMBLY |
Remove the washer from the generator rotor.
Remove the drive end frame space collar.
Remove the rotor from the drive end frame.
| 7. INSPECT GENERATOR DRIVE END FRAME BEARING |
![]() |
Check that the bearing is not rough or worn, and that it rotates smoothly.
If necessary, replace the drive end frame bearing.
| 8. REMOVE GENERATOR DRIVE END FRAME BEARING |
![]() |
Remove the 4 screws and bearing retainer.
![]() |
Using SST and a hammer, tap out the bearing.