GENERATOR > REASSEMBLY |
| 1. INSTALL GENERATOR DRIVE END FRAME BEARING |
![]() |
Using SST and a press, press in a new bearing.
![]() |
Align the claws of the bearing retainer with the grooves inside the drive end frame.
Install the bearing retainer with the 4 screws.
| 2. INSTALL GENERATOR ROTOR ASSEMBLY |
Install the generator rotor to the drive end frame.
Install the generator drive end frame space collar to the generator rotor.
Install the washer to the generator rotor.
| 3. INSTALL GENERATOR COIL ASSEMBLY |
![]() |
Using a 21 mm deep socket wrench and press, slowly press in the generator coil assembly.
![]() |
Install the generator coil assembly with the 4 through bolts.
| 4. INSTALL GENERATOR BRUSH HOLDER ASSEMBLY |
![]() |
While pushing the 2 brushes inside brush holder, insert a φ1.0 mm (0.039 in.) pin into the brush holder hole.
![]() |
Install the brush holder with the 2 screws.
Pull out the pin from the brush holder.
| 5. INSTALL TERMINAL INSULATOR |
![]() |
Install the terminal insulator.
| 6. INSTALL GENERATOR REAR END COVER |
![]() |
Install the end cover with the 3 nuts.
| 7. INSTALL GENERATOR PULLEY |
Install the pulley to the rotor shaft by tightening the generator pulley nut by hand.
![]() |
Install SST 1-A and B to the rotor shaft.
| Item | Part No. |
| SST 1-A and B | 09820-06010 |
| SST 2 | 09820-06021 |
Hold SST 1-A with a torque wrench, and tighten SST 1-B clockwise with the specified torque.
![]() |
Mount the generator in a vise between aluminum plate.
Insert SST 2 to attach it to pulley nut.
![]() |
Tighten the pulley nut by turning SST 1-A in the direction shown in the illustration.
Remove the generator from SST 2.
![]() |
Turn SST 1-A in the direction shown in the illustration, and remove SST 1-A and B.
Turn the pulley, and check that the pulley moves smoothly.