CHARGING SYSTEM > Noise Occurs from V-ribbed Belt or Generator Assembly |
| 1.CONFIRM PROBLEM SYMPTOM |
Confirm the problem symptom.
| Symptom | Proceed to |
| Noise occurs from fan and generator V belt | A |
| Noise occurs from generator assembly | B |
|
| ||||
| A | |
| 2.CHECK FAN AND GENERATOR V BELT FOR WEAR |
Check the fan and generator V belt for wear or damage.
|
| ||||
| OK | |
| 3.CHECK GENERATOR PULLEY WITH CLUTCH FOR WEAR |
Check the generator pulley with clutch grooves for wear or damage.
| Result | Proceed to |
| OK | A |
| NG (for DENSO Made) | B |
| NG (for BOSCH Made) | C |
|
| ||||
|
| ||||
| A | |
| 4.CHECK FOR NOISE WHILE CLUTCH PULLEY IS OPERATING |
Start the engine and check the generator pulley with clutch for looseness.
|
| ||||
| OK | |
| 5.INSPECT GENERATOR PULLEY WITH CLUTCH (UNIT INSPECTION) |
Remove the generator assembly.
Check the installation condition of the generator pulley cap.
Check for grease leaks (for wet pulley) or particle formation due to friction (for dry pulley).
Check the generator pulley with clutch for misalignment (interference with the generator assembly).
![]() |
Turn the generator pulley with clutch clockwise and counterclockwise by hand and check for noise.
Turn the generator pulley with clutch clockwise and counterclockwise by hand and visually check for runout.
![]() |
Using a screwdriver, hold the fan of the generator rotor assembly located inside the generator assembly in place and check that the generator pulley with clutch locks when turned clockwise and turns freely when turned counterclockwise.
| Result | Proceed to |
| OK | A |
| NG (for DENSO Made) | B |
| NG (for BOSCH Made) | C |
|
| ||||
|
| ||||
| A | ||
| ||
| 6.CHECK FOR NOISE WHEN ROTOR IS TURNING FREELY |
Perform a road test and check that noise does not occur when decelerating.
Turn the engine off and check that no noise is produced by the generator pulley with clutch as the engine stops.
| Result | Proceed to |
| OK | A |
| NG (for DENSO Made) | B |
| NG (for BOSCH Made) | C |
|
| ||||
|
| ||||
| A | |
| 7.CHECK ENGAGEMENT OF GENERATOR PULLEY WITH CLUTCH |
Remove the generator assembly.
![]() |
Using a screwdriver, hold the fan in the generator rotor assembly located inside the generator assembly in place and check that the generator pulley with clutch locks when turned clockwise (locking direction).
| Result | Proceed to |
| OK | A |
| NG (for DENSO Made) | B |
| NG (for BOSCH Made) | C |
|
| ||||
|
| ||||
| A | ||
| ||