Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > TERMINALS OF ECU



CHECK THEFT WARNING ECU ASSEMBLY
B275963E03
  1. Disconnect the T33 theft warning ECU assembly connector.

  2. Measure the resistance and voltage according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    T33-1 (E) - Body ground
    B-W - Body ground
    Ignition power supply
    Ground
    Below 1 Ω
    T33-4 (+B1) - T33-1 (E)
    L-Y - B-W
    L-Y - B-W
    Always
    11 to 14 V
    T33-14 (+B2) - T33-1 (E))
    LG - B-W
    LG - B-W
    Always
    11 to 14 V
    T33-18 (IG) - T33-1 (E))
    R-L - B-W
    Ignition power supply
    Ignition switch off
    Below 1 V
    Ignition switch ON
    11 to 14 V

    1. If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the T33 theft warning ECU assembly connector.

  4. Measure the resistance and voltage according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    T33-5 (KSW) - Body ground
    G-Y - Body ground
    Unlock warning switch input signal
    No key in ignition key cylinder
    10 kΩ or higher
    Key inserted in ignition key cylinder
    Below 1 Ω
    T33-7 (CTY) - T33-1 (E)
    R-L - B-W
    All courtesy light switches input signal
    One or more doors open
    Below 1 V
    All doors closed
    11 to 14 V
    T33-9 (DSWH) - T33-1 (E)
    G-R - B-W
    Hood lock assembly (security courtesy switch) input signal
    Engine hood fully closed
    Below 1 Ω
    Engine hood open
    10 kΩ or higher
    T33-11 (HORN) - T33-1 (E)
    W-R - B-W
    Vehicle horns output signal
    Alarm sounding state
    Below 1 V
    Armed state
    11 to 14 V
    T33-13 (SH-) - T33-1 (E)
    B - B-W
    Security horn output signal
    Security horn assembly is sounding (theft deterrent system is in alarm sounding state)
    Alternating between below 1 V and 11 to 14 V
    T33-27 (IND) - T33-1 (E)
    G-R - B-W
    Security indicator light assembly output signal
    Security indicator light is flashing (theft deterrent system is operating)
    Alternating between below 1 V and 11 to 14 V
    T33-28 (HAZD) - T33-1 (E)
    G-O - B-W
    All hazard warning light output signals
    Hazard warning lights and side turn signal lights are flashing (theft deterrent system is in alarm sounding state)
    Below 1 V

    1. If the result is not as specified, the theft warning ECU assembly may have a malfunction.