Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > Driver Side Door Courtesy Switch Circuit


DESCRIPTION

The theft warning ECU assembly detects the condition of the front door courtesy light switch assembly LH.

WIRING DIAGRAM


B275968E11


INSPECTION PROCEDURE

1.CHECK COMBINATION METER ASSEMBLY
  1. When the driver side door is opened/closed, check that the indicator in the combination meter operates normally.

    OK:
    Indicator operates normally.



NG
Go to step 3
OK


2.CHECK HARNESS AND CONNECTOR (COMBINATION METER - THEFT WARNING ECU)
  1. Disconnect the C26 combination meter assembly connector.

  1. Disconnect the T33 theft warning ECU assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    C26-17 - T33-7 (CTY)
    Always
    Below 1 Ω
    C26-17 or T33-7 (CTY) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    C26-17 - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

3.INSPECT FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY LH
B276106E01
  1. Remove the front door courtesy light switch assembly LH (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - Body ground
    Not pushed (ON)
    Below 1 Ω
    1 - Body ground
    Pushed (OFF)
    10 kΩ or higher
    Text in Illustration 
    *a
    Not pushed (ON)
    *b
    Pushed (OFF)
    *c
    Body ground



NG
REPLACE FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY LH (Click here)
OK


4.CHECK HARNESS AND CONNECTOR (COMBINATION METER - FRONT DOOR COURTESY LIGHT SWITCH LH)
  1. Disconnect the C26 combination meter assembly connector.

  1. Disconnect the D4 front door courtesy light switch assembly LH connector.

  1. Measure the resistance according to the value(s) in the table below

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    C26-16 - D4-1
    Always
    Below 1 Ω
    C26-16 or D4-1 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)