THEFT DETERRENT SYSTEM > Driver Side Door Courtesy Switch Circuit |

| 1.CHECK COMBINATION METER ASSEMBLY |
When the driver side door is opened/closed, check that the indicator in the combination meter operates normally.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (COMBINATION METER - THEFT WARNING ECU) |
Disconnect the C26 combination meter assembly connector.
Disconnect the T33 theft warning ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| C26-17 - T33-7 (CTY) | Always | Below 1 Ω |
| C26-17 or T33-7 (CTY) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| C26-17 - Body ground | Always | 11 to 14 V |
|
| ||||
| OK | ||
| ||
| 3.INSPECT FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY LH |
![]() |
Remove the front door courtesy light switch assembly LH (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - Body ground | Not pushed (ON) | Below 1 Ω |
| 1 - Body ground | Pushed (OFF) | 10 kΩ or higher |
| *a | Not pushed (ON) |
| *b | Pushed (OFF) |
| *c | Body ground |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (COMBINATION METER - FRONT DOOR COURTESY LIGHT SWITCH LH) |
Disconnect the C26 combination meter assembly connector.
Disconnect the D4 front door courtesy light switch assembly LH connector.
Measure the resistance according to the value(s) in the table below
| Tester Connection | Condition | Specified Condition |
| C26-16 - D4-1 | Always | Below 1 Ω |
| C26-16 or D4-1 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||