Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > Front Passenger Side Door Courtesy Switch Circuit


DESCRIPTION

The theft warning ECU assembly detects the condition of the front door courtesy light switch assembly RH.

WIRING DIAGRAM


B276107E24


INSPECTION PROCEDURE

1.INSPECT FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY RH
B276106E01
  1. Remove the front door courtesy light switch assembly RH (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - Body ground
    Not pushed (ON)
    Below 1 Ω
    1 - Body ground
    Pushed (OFF)
    10 kΩ or higher
    Text in Illustration 
    *a
    Not pushed (ON)
    *b
    Pushed (OFF)
    *c
    Body ground



NG
REPLACE FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY RH (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (FRONT DOOR COURTESY LIGHT SWITCH RH - THEFT WARNING ECU)
  1. Disconnect the D5 front door courtesy light switch assembly RH connector.

  1. Disconnect the T33 theft warning ECU assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D5-1 - T33-7 (CTY)
    Always
    Below 1 Ω
    D5-1 or T33-7 (CTY) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)