Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > Rear Door Courtesy Switch LH Circuit


DESCRIPTION

The theft warning ECU assembly detects the condition of the rear door courtesy light switch assembly LH.

WIRING DIAGRAM


B276107E25


INSPECTION PROCEDURE

1.INSPECT REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY LH
B276106E01
  1. Remove the rear door courtesy light switch assembly LH (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - Body ground
    Not pushed (ON)
    Below 1 Ω
    1 - Body ground
    Pushed (OFF)
    10 kΩ or higher
    Text in Illustration 
    *a
    Not pushed (ON)
    *b
    Pushed (OFF)
    *c
    Body ground



NG
REPLACE REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY LH (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (REAR DOOR COURTESY LIGHT SWITCH LH - THEFT WARNING ECU)
  1. Disconnect the D6 rear door courtesy light switch assembly LH connector.

  1. Disconnect the T33 theft warning ECU assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D6-1 - T33-7 (CTY)
    Always
    Below 1 Ω
    D6-1 or T33-7 (CTY) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)