Home › BODY › ENGINE HOOD / DOOR › BACK DOOR SUPPORT

BACK DOOR SUPPORT > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. INSTALL BACK DOOR STAY ASSEMBLY LH
  1. When using a new bolt:

    1. Clean the threaded portion on the vehicle body with a non-residue solvent.

  1. When reusing a bolt:

    1. Clean the threaded portion on the vehicle body and bolt with a non-residue solvent.

    2. Apply adhesive to the threads of the bolt.

      Adhesive:
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

  1. Install the back door stay with the 4 bolts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

    CAUTION:
    Install the back door stay while holding the back door.