Home › ENGINE ยท 1KD-FTV › COOLING › RADIATOR

RADIATOR > DISASSEMBLY

for Preparation Click here



1. REMOVE RADIATOR BRACKET SUB-ASSEMBLY


    A099949E01
  1. Remove the 4 bolts and 2 brackets.



2. REMOVE RADIATOR DRAIN COCK PLUG
  1. Remove the drain plug.

  1. Remove the O-ring.



3. ASSEMBLE SST


    A113337E07
  1. Install the claw to part A of the overhaul handle as shown in the illustration.

    SST
    09230-01010   (09231-01010, 09231-01030)

  1. While squeezing the handle, adjust the stopper bolt so that dimension B is as specified below.

    Dimension B:
    0.2 to 0.3 mm (0.008 to 0.012 in.)

    NOTICE:
    If this adjustment is not performed, the claw will be damaged.



4. UNCAULK LOCK PLATE


    A113338E01
  1. Using SST to release the caulking, squeeze the handle until stopped by the stopper bolt.

    SST
    09230-01010   (09231-01010, 09231-01030)



5. REMOVE RADIATOR TANK UPPER AND TANK LOWER


    A099688E01
  1. Lightly tap the bracket of the radiator (or radiator hose inlet or outlet) with a plastic-faced hammer and remove the tank.

    NOTICE:
    Do not tap automatic transmission oil cooler pipe.

  1. Remove the O-ring.



6. REMOVE OIL COOLER ASSEMBLY (for Automatic Transmission)


    A099689E01
  1. Remove the 2 cooler pipes.

  1. Remove the 2 nuts, 2 plate washers and oil cooler.

  1. Remove the 2 O-rings from the oil cooler.