RADIATOR > REASSEMBLY |
| 1. INSTALL OIL COOLER (for Automatic Transmission) |
![]() |
Install 2 new O-rings to the oil cooler.
Install the oil cooler and 2 plate washers to the lower radiator tank with the 2 nuts.
Install the 2 cooler pipes.
| 2. INSPECT LOCK PLATE FOR DAMAGE |
![]() |
Inspect the lock plate for damage.
| *1 | Lock Plate |
| *2 | Radiator Core |
| 3. INSTALL UPPER RADIATOR TANK AND LOWER RADIATOR TANK |
![]() |
Check that there are no foreign objects in the lock plate groove, and then install a new O-ring. Make sure the O-ring is not twisted.
| *1 | O-Ring |
| *a | CORRECT |
| *b | INCORRECT |
| *c | Normal |
| *d | Twisted |
Install the tank without damaging the O-ring.
![]() |
Tap the lock plate with a plastic-faced hammer so that there is no gap between the lock plate and tank.
| *1 | Tank |
| *2 | Lock Plate |
| *a | CORRECT |
| *b | INCORRECT |
| 4. ASSEMBLE SST |
![]() |
Install the punch assembly to part A of the overhaul handle as shown in the illustration.
| *1 | Dimension B |
| *2 | Part A |
| *3 | Stopper Bolt |
While gripping the handle, adjust the stopper bolt so that dimension B is as specified below.
| 5. CAULK LOCK PLATE |
![]() |
Lightly press SST against the lock plate in the order shown in the illustration. After repeating this a few times, fully caulk the lock plate by squeezing the handle until stopped by the stopper bolt.
| *1 | Stopper Bolt |
| *2 | Tank |
| *3 | Lock Plate |
![]() |
![]() |
![]() |
Check the lock plate height H after completing the caulking.
| 6. INSTALL RADIATOR DRAIN COCK PLUG |
Install a new O-ring to the radiator drain cock plug.
Install the radiator drain cock plug.
| 7. INSPECT FOR WATER LEAKS |
![]() |
Plug the inlet and outlet pipes of the radiator with SST.
Using a radiator cap tester, apply pressure to the radiator.
Submerge the radiator in water.
![]() |
Inspect for leaks.
| *1 | Tank |
| *2 | Lock Plate |
| *3 | O-Ring |
| 8. INSTALL RADIATOR BRACKET SUB-ASSEMBLY |
Install the 2 radiator brackets with the 4 bolts.