Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › REAR COOLING UNIT

REAR COOLING UNIT > REASSEMBLY

for Preparation Click here



1. INSTALL REAR COOLING UNIT EXPANSION VALVE
  1. Sufficiently apply compressor oil to 2 new O-rings and the fitting surface of the hose joint.

    Compressor oil:
    ND-OIL 8 or equivalent

  1. Install the 2 O-rings to the evaporator sub-assembly.

  1. Install the rear cooling unit expansion valve to the evaporator sub-assembly.



2. INSTALL AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY
  1. Sufficiently apply compressor oil to 2 new O-rings and the fitting surface of the hose joint.

    Compressor oil:
    ND-OIL 8 or equivalent

  1. Install the 2 O-rings to the air conditioning tube and accessory assembly.

  1. Using a 4 mm socket hexagon wrench, install the air conditioning tube and accessory assembly to the evaporator with the 2 hexagon bolts.

    Torque:
    3.4 N*m{ 34 kgf*cm , 30 in.*lbf }

  1. Attach the 3 claws to install the cooling unit case (motor side).

  1. Install the 9 screws.



3. INSTALL REAR BLOWER MOTOR WITH FAN SUB-ASSEMBLY
  1. Install the rear blower motor with fan sub-assembly with the 3 screws.



4. INSTALL NO. 2 COOLER UNIT DRAIN HOSE
  1. Install the No. 2 cooler unit drain hose.



5. INSTALL BLOWER (REAR) RESISTOR
  1. Install the blower (rear) resistor with the 2 screws.

  1. Connect the connector.



6. INSTALL NO. 1 COOLER AIR DUCT
  1. Install the No. 1 cooler air duct with the 3 screws.