Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > Engine Hood Courtesy Switch Circuit


DESCRIPTION

The security courtesy switch is installed together with the hood lock assembly. This switch turns off when the engine hood is opened and turns on when the engine hood is closed.

WIRING DIAGRAM


B281448E06


INSPECTION PROCEDURE

1.INSPECT HOOD LOCK ASSEMBLY (SECURITY COURTESY SWITCH)
B282278E01
  1. Remove the the hood lock assembly (security courtesy switch) (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Unlock position
    10 kΩ or higher
    Lock position
    Below 1 Ω

    Text in Illustration 
    *a
    Unlock position
    *b
    Lock position



NG
REPLACE HOOD LOCK ASSEMBLY (SECURITY COURTESY SWITCH) (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (HOOD LOCK - THEFT WARNING ECU AND BODY GROUND)
  1. Disconnect the E2 hood lock assembly (security courtesy switch) connector.

  1. Disconnect the T33 theft warning ECU assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E2-1 - T33-9 (DSWH)
    Always
    Below 1 Ω
    E2-1 or T33-9 (DSWH) - Body ground
    Always
    10 kΩ or higher
    E2-2 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)