THEFT DETERRENT SYSTEM > Engine Hood Courtesy Switch Circuit |

| 1.INSPECT HOOD LOCK ASSEMBLY (SECURITY COURTESY SWITCH) |
![]() |
Remove the the hood lock assembly (security courtesy switch) (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - 2 | Unlock position | 10 kΩ or higher |
| Lock position | Below 1 Ω |
| *a | Unlock position |
| *b | Lock position |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (HOOD LOCK - THEFT WARNING ECU AND BODY GROUND) |
Disconnect the E2 hood lock assembly (security courtesy switch) connector.
Disconnect the T33 theft warning ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E2-1 - T33-9 (DSWH) | Always | Below 1 Ω |
| E2-1 or T33-9 (DSWH) - Body ground | Always | 10 kΩ or higher |
| E2-2 - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||