Home › ENGINE · 2TR-FE › ENGINE CONTROL SYSTEM › A/F SENSOR HEATER RELAY (w/ Secondary Air Injection System)

A/F SENSOR HEATER RELAY (w/ Secondary Air Injection System) > ON-VEHICLE INSPECTION

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


3. REMOVE AIR FUEL RATIO SENSOR RELAY (Marking: A/F)
  1. Remove the engine room relay block cover.

  1. Remove the starter relay from the engine room relay block.



4. INSPECT A/F RELAY


    B060778E19
  1. Inspect the resistance of the air fuel ratio sensor relay.

    Standard Resistance:
    Terminal Connection
    Specified Condition
    3 - 5
    10 kΩ or higher
    Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)

    If the result is not as specified, replace the air fuel ratio sensor relay.



5. INSTALL A/F RELAY


6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


7. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.