Home › ENGINE ยท 1GR-FE › CHARGING › GENERATOR (for BOSCH Made)

GENERATOR (for BOSCH Made) > DISASSEMBLY

for Preparation Click here



1. REMOVE GENERATOR REAR END COVER


    A117269
  1. Remove the 2 terminal covers by turning them counterclockwise.



    A117270
  1. Using a 15 mm socket wrench, remove the 2 nuts from the end cover.

  1. Remove the screw and end cover.



2. REMOVE VOLTAGE REGULATOR SUB-ASSEMBLY WITH BRUSH


    A117271
  1. Remove the 3 screws and regulator.



3. REMOVE GENERATOR STATOR SUB-ASSEMBLY WITH RECTIFIER


    A117272
  1. Remove the 4 screws.



    A117273
  1. Using a screwdriver, pry out the stator.



4. REMOVE FITTING RING


A117274


5. REMOVE GENERATOR PULLEY
  1. Fix the generator in a vise between aluminum plates.

    NOTICE:
    Do not damage the generator.



    A197371E02
  1. Set SST, a ball joint lock nut wrench and an 8 mm bi-hexagon wrench as shown in the illustration.

    SST
    09820-30020  

  1. Hold the 8 mm bi-hexagon wrench in place and turn SST and the ball joint lock nut wrench counterclockwise to loosen the nut.

  1. Remove the nut, washer and generator pulley.



6. REMOVE GENERATOR ROTOR ASSEMBLY


    A117276
  1. Using a press, press out the rotor, and then remove the spacer ring.



7. REMOVE GENERATOR DRIVE END FRAME BEARING


    A225129
  1. Check that the bearing is not rough or worn, and that it rotates smoothly.
    If necessary, replace the drive end frame bearing.



    A222318
  1. Remove the 4 screws and retainer plate.



    A222319E01
  1. Using SST and a hammer, tap out the bearing.

    SST
    09950-60010   (09951-00250)
    09950-70010   (09951-07100)