Home › ENGINE ยท 1KD-FTV › CHARGING › GENERATOR (for BOSCH Made)

GENERATOR (for BOSCH Made) > DISASSEMBLY

for Preparation Click here



1. REMOVE GENERATOR PULLEY CAP
  1. Using a screwdriver, remove the generator pulley cap from the generator pulley with clutch.



2. LOOSEN GENERATOR PULLEY WITH CLUTCH
  1. Mount the generator in a vise between aluminum plates.

    NOTICE:
    Do not damage the generator.



    A200681E01
  1. Set SST and an 8 mm bi-hexagon wrench to the pulley as shown in the illustration.

    SST
    09820-30010  



    A200682E01
  1. Hold SST in place, rotate the 8 mm bi-hexagon wrench clockwise, and loosen the generator pulley with clutch.



3. REMOVE GENERATOR REAR END COVER


    A117269
  1. Remove the 2 terminal covers by turning them counterclockwise.



    A117270
  1. Using a 15 mm socket wrench, remove the 2 nuts from the end cover.

  1. Remove the screw and end cover.



4. REMOVE VOLTAGE REGULATOR ASSEMBLY WITH BRUSH
  1. Remove the protective tower.



    A117271
  1. Remove the 3 screws and regulator.



5. REMOVE GENERATOR STATOR SUB-ASSEMBLY WITH RECTIFIER


    A117272
  1. Remove the 4 screws.



    A117273
  1. Using a screwdriver, pry off the stator.



6. REMOVE FITTING RING


A117274


7. REMOVE GENERATOR ROTOR ASSEMBLY

NOTICE:
Do not drop the generator rotor assembly.

  1. Remove the generator pulley with clutch.



    A117276
  1. Using a press, press out the generator rotor and remove the spacer ring.



8. REMOVE GENERATOR DRIVE END FRAME BEARING


    A225502
  1. Check that the bearing is not rough or worn, and that it rotates smoothly.
    If necessary, replace the drive end frame bearing.



    A222321
  1. Remove the 4 screws and retainer plate.



    A222322
  1. Using SST and a hammer, tap out the bearing.

    SST
    09950-60010   (09951-00250)
    09950-70010   (09951-07100)