Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT LEVELING SWITCH

HEADLIGHT LEVELING SWITCH > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE NO. 1 SWITCH HOLE BASE


B278246E01
  1. Put protective tape around the No. 1 switch hole base.
    Text in Illustration 
    *1
    Protective Tape

  1. Using a moulding remover, detach the 5 claws.

  1. Disconnect the connectors and remove the No. 1 switch hole base.



3. REMOVE HEADLIGHT LEVELING SWITCH


B122916
  1. Detach the 2 claws and remove the headlight leveling switch.