AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System) > Power Heater Switch Circuit |

| 1.INSPECT HEATER SWITCH ASSEMBLY |
![]() |
Remove the heater switch assembly (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 4 - 1 | Heater switch assembly on | Below 1 Ω |
| 4 - 1 | Heater switch assembly off | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (HEATER SWITCH - AIR CONDITIONING AMPLIFIER AND BODY GROUND) |
Disconnect the P20 heater switch assembly connector.
Disconnect the A45 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| P20-4 - A45-8 (HEAT) | Always | Below 1 Ω |
| P20-5 - A45-5 (SWIN) | ||
| P20-4 - Body ground | Always | 10 kΩ or higher |
| P20-5 - Body ground | ||
| P20-1 - Body ground | Always | Below 1 Ω |
| P20-8 - Body ground |
|
| ||||
| OK | ||
| ||