Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)

AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System) > Power Heater Switch Circuit

for Preparation Click here


DESCRIPTION

The PTC heater operates when the heater switch assembly is on and the following conditions are met:
  1. Engine idling.
  2. Temperature switch MAX COLD to MAX HOT.
  3. Coolant temperature 65°C (149°F) or less.
  4. Ambient temperature 10°C (149°F) or less.
  5. Generator is operating.
  6. Blower switch on is in any position other than off.

WIRING DIAGRAM


E236774E01


INSPECTION PROCEDURE

1.INSPECT HEATER SWITCH ASSEMBLY


    E236775
  1. Remove the heater switch assembly (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    4 - 1
    Heater switch assembly on
    Below 1 Ω
    4 - 1
    Heater switch assembly off
    10 kΩ or higher



NG
REPLACE HEATER SWITCH ASSEMBLY (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (HEATER SWITCH - AIR CONDITIONING AMPLIFIER AND BODY GROUND)
  1. Disconnect the P20 heater switch assembly connector.

  1. Disconnect the A45 air conditioning amplifier assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    P20-4 - A45-8 (HEAT)
    Always
    Below 1 Ω
    P20-5 - A45-5 (SWIN)
    P20-4 - Body ground
    Always
    10 kΩ or higher
    P20-5 - Body ground
    P20-1 - Body ground
    Always
    Below 1 Ω
    P20-8 - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)