Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)

DTC    14    Engine Coolant Temperature Communication Circuit

for Preparation Click here


DESCRIPTION

The engine coolant temperature sensor connected to the ECM detects the engine coolant temperature, which is used for warm up control when the engine is cold. The engine coolant temperature sensor sends a signal to the air conditioning amplifier assembly via the ECM.

DTC Code
DTC Detection Condition
Trouble Area
14
An open or short in engine coolant temperature communication circuit
  1. ECD system
  2. SFI system
  3. Air conditioning amplifier assembly
  4. Harness or connector

WIRING DIAGRAM


E232895E05


INSPECTION PROCEDURE

1.CHECK FOR DTC (ENGINE CONTROL SYSTEM)
  1. Clear the DTCs.

    1. for 1KD-FTV (w/ EGR Cooler): Click here.
    2. for 1KD-FTV (w/o EGR Cooler): Click here .
    3. for 1GR-FE: Click here.

  1. Check the DTCs.

    1. for 1KD-FTV (w/ EGR Cooler): Click here.
    2. for 1KD-FTV (w/o EGR Cooler): Click here.
    3. for 1GR-FE: Click here.
    Result 
    Result
    Proceed to
    DTC (P0115, P0117 or P0118) is not output.
    A
    DTC (P0115, P0117 or P0118) is output. (for 1KD-FTV [w/ EGR Cooler])
    B
    DTC (P0115, P0117 or P0118) is output. (for 1KD-FTV [w/o EGR Cooler])
    C
    DTC (P0115, P0117 or P0118) is output. (for 1GR-FE)
    D



B
GO TO ECD SYSTEM (Click here)

C
GO TO ECD SYSTEM (Click here)

D
GO TO SFI SYSTEM (Click here)
A


2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - ECM)
  1. Disconnect the A44 air conditioning amplifier assembly connector.

  1. Disconnect the E4*1 or E13*2 ECM connector.

    1. *1: for 1KD-FTV
    2. *2: for 1GR-FE

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for 1KD-FTV:
    Tester Connection
    Condition
    Specified Condition
    A44-8 (TW) - E4-2 (THWO)
    Always
    Below 1 Ω
    A44-8 (TW) - Body ground
    Always
    10 kΩ or higher
    for 1GR-FE:
    Tester Connection
    Condition
    Specified Condition
    A44-8 (TW) - E13-14 (THWO)
    Always
    Below 1 Ω
    A44-8 (TW) - Body ground
    Always
    10 kΩ or higher

    Result 
    Result
    Proceed to
    OK (When troubleshooting according to problem symptoms table.)
    A
    OK (When troubleshooting according to DTC.)
    B
    NG
    C



B
REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)

C
REPAIR OR REPLACE HARNESS OR CONNECTOR
A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)