Home › DRIVE LINE › PROPELLER SHAFT › PROPELLER SHAFT ASSEMBLY (except DANA Made)

PROPELLER SHAFT ASSEMBLY (except DANA Made) > INSPECTION

for Preparation Click here



1. INSPECT REAR PROPELLER SHAFT ASSEMBLY


    C029928
  1. Using a dial indicator, measure the propeller shaft runout.

    Maximum runout:
    0.3 mm (0.0118 in.)

    If the shaft runout is more than the maximum, replace the propeller shaft.



2. INSPECT UNIVERSAL JOINT SPIDER ASSEMBLY
  1. Check the spider bearings for wear or damage.

  1. Check each spider bearing's axial play by turning the yoke while holding the shaft tightly.

    Maximum bearing axial play:
    0 to 0.05 mm (0 to 0.00197 in.)

    If the bearing axial play is more than the maximum, replace the spider bearing.