Home › DRIVE LINE › PROPELLER SHAFT › PROPELLER SHAFT ASSEMBLY (for DANA Made)

PROPELLER SHAFT ASSEMBLY (for DANA Made) > INSPECTION

for Preparation Click here



1. INSPECT PROPELLER SHAFT AND INTERMEDIATE SHAFT
  1. Using a dial indicator, measure the propeller shaft and intermediate shaft runout.

    Maximum Runout:
    Item
    Specified Condition
    Propeller shaft
    0.8 mm (0.0315 in.)
    Intermediate shaft
    0.8 mm (0.0315 in.)

    If the runout is more than the maximum, replace the shaft.



2. INSPECT UNIVERSAL JOINT SPIDER ASSEMBLY
  1. Check the spider bearings for wear or damage.

  1. Check each spider bearing's axial play by turning the yoke while holding the shaft tightly.

    Maximum bearing axial play:
    0 to 0.05 mm (0 to 0.00197 in.)

    If the axial play is more than the maximum, replace the spider bearing.



3. INSPECT CENTER NO. 1 SUPPORT BEARING ASSEMBLY (for Pre-Runner)


C118618
  1. Turn the center bearing with your hand and check that it turns smoothly without catching and that there are no cracks or damage.
    If there are any defects, replace the center bearing.
    If there is any damage to the lip of the center bearing case, replace the bearing.