Home › ENGINE ยท 2KD-FTV › STARTING › STARTER (for 2.7 kW Type)

STARTER (for 2.7 kW Type) > DISASSEMBLY

for Preparation Click here



1. REMOVE STARTER YOKE ASSEMBLY


    A115884E03
  1. Remove the nut and disconnect the lead wire from terminal C.
    Text in Illustration 
    *1
    Terminal C

  1. Remove the 2 through bolts.

  1. Pull out the starter yoke together with the armature.

  1. Remove the felt washer from the armature.



2. REMOVE STARTER CLUTCH SUB-ASSEMBLY


    A102626
  1. Remove the 3 screws and magnet starter switch assembly.



    A253302E01
  1. Remove the return spring, idler gear, clutch roller, retainer and starter clutch assembly from the starter drive housing.
    Text in Illustration 
    *1
    Return Spring
    *2
    Starter Clutch
    *3
    Starter Drive Housing
    *4
    Clutch Roller
    *5
    Retainer
    *6
    Idler Gear



    A115020E04
  1. Using a magnet hand, remove the steel ball from the clutch shaft hole.
    Text in Illustration 
    *1
    Magnet Hand



3. REMOVE STARTER BRUSH HOLDER ASSEMBLY


    A102628
  1. Remove the 2 screws and commutator end frame from the starter yoke.



    A102629
  1. Disconnect the 4 starter brushes from the starter brush holder.

    1. Using a screwdriver, pull back the spring.

    2. Disconnect the brush from the brush holder.

  1. Remove the starter brush holder from the starter yoke.



4. REMOVE STARTER ARMATURE ASSEMBLY