Home › BODY › WINDSHIELD / WINDOWGLASS › WINDOW DEFOGGER SWITCH

WINDOW DEFOGGER SWITCH > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT AIR CONDITIONING AMPLIFIER ASSEMBLY (REAR WINDOW DEFOGGER SWITCH) (for Automatic Air Conditioning System)


B089046E02
  1. Measure the voltage of the connector.

    Standard measurement:

    Tester Connection
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    A16 - 12 (RDFG) - A16 - 1 (GND)
    R-L - L
    Rear defogger switch signal
    Ignition switch ON
    Rear window defogger switch OFF
    10 to 14 V
    A16 - 12 (RDFG) - A16 - 1 (GND)
    R-L - L
    Rear defogger switch signal
    Ignition switch ON
    Rear window defogger switch ON
    Below 1.0 V

    If the result is not as specified, replace the A/C amplifier and heater control base sub-assembly.



2. INSPECT REAR WINDOW DEFOGGER SWITCH ASSEMBLY (for Manual Air Conditioning System)


B085675E02
  1. Check the illumination area of the switch.

    Standard measurement:
    Measurement Condition
    Specified Condition
    Battery positive (+) → 1 (ILL+)
    Battery negative (-) → 1 (ILL+)
    Illuminates

    If the result is not as specified, replace the switch assembly.

    HINT:
    The ON/OFF indicator of the switch will not illuminate.



    B085676E02
  1. Check ON/OFF indicator of the switch.

    1. Push the switch several times. Check that the ON/OFF indicator illuminates or turns off according to switch operation.

      Standard measurement:
      Measurement Condition
      Specified Condition
      Specified Condition
      Battery positive (+) → 5 (IG)
      Battery negative (-) → 3 (E)
      Defogger switch ON
      Illuminates

      If the result is not as specified, replace the switch assembly.

      HINT:
      The illumination area of the switch will not illuminate.



    B085677E01
  1. Measure the resistance of the switch.

    Standard resistance:
    Measurement Condition
    Specified Condition
    Specified Condition
    4 (D) - 3 (E)
    ON
    Below 1 Ω
    4 (D) - 3 (E)
    OFF
    10 kΩ or higher

    If the result is not as specified, replace the switch assembly.