TRANSFER OIL > INSPECTION |
| 1. CHECK TRANSFER OIL |
Remove the case plug (for filler) and gasket.
![]() |
Check that the oil level is between 0 to 5.0 mm (0 to 0.20 in.) from the bottom lip of the case plug (for filler) hole.
If the result is not as specified, add transfer oil.
| Transfer Oil Type | Oil grade | Viscosity |
| Toyota Genuine Transfer Gear Oil LF or Equivalent | - | SAE 75W |
| Transfer Oil Type | Oil grade | Viscosity |
| Hypoid Gear Oil | API GL-5 | SAE 75W-90 |
| Toyota Genuine Transfer Gear Oil LF or Equivalent | - | SAE 75W |
When the oil level is too low, check for oil leakage.
Install a new gasket into the case plug (for filler) and then tighten the plug.
| 2. ADD TRANSFER OIL |
Remove the case plug (for filler) and gasket.
Pour oil so that the oil level is between 0 to 5.0 mm (0 to 0.197 in.) from the bottom lip of the case plug (for filler) hole.
Wait approximately 5 minutes and check that the oil level has not changed.
Install a new gasket and the case plug (for filler).