DTC U0100 Lost Communication with ECM / PCM "A" |
| DTC Code | DTC Detection Condition | Trouble Area |
| U0100 | All conditions are met for 1.25 seconds (1-trip detection logic):
|
|

| 1.CHECK HARNESS AND CONNECTOR (ECM - TCM) |
Disconnect the E27 ECM connector.
Disconnect the T35 TCM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E27-24 (CAN+) - T35-21 (CAN+) | Always | Below 1 Ω |
| E27-18 (CAN-) - T35-20 (CAN-) | Always | Below 1 Ω |
| E27-24 (CAN+) or T35-21 (CAN+) - Body ground or other terminals | Always | 10 kΩ or higher |
| E27-18 (CAN-) or T35-20 (CAN-) - Body ground or other terminals | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.CHECK IF DTC OUTPUT RECURS (DTC U0100) |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / ECT / Trouble Codes / Clear.
Replace the TCM (Click here).
Start the engine.
Enter the following menus: Powertrain / ECT / Trouble Codes.
Read the DTCs using the GTS.
| Result | Proceed to |
| U0100 is output | A |
| DTCs are not output | B |
|
| ||||
| A | ||
| ||