Home › TRANSMISSION · A750F AUTOMATIC TRANSMISSION › AUTOMATIC TRANSMISSION SYSTEM (for 1KD-FTV with i-ART)

DTC    U0100    Lost Communication with ECM / PCM "A"

for Preparation Click here


DESCRIPTION

The ECM communicates with the TCM using the Controller Area Network (CAN).
If there is a problem with this communication, the TCM stores a DTC.

DTC Code
DTC Detection Condition
Trouble Area
U0100
All conditions are met for 1.25 seconds (1-trip detection logic):
  1. Ignition switch is ON.
  2. Battery voltage is 10.5 V or higher.
  3. There is no communication between the ECM and TCM.
  1. Harness or connector
  2. ECM
  3. TCM

WIRING DIAGRAM


C217589E03


INSPECTION PROCEDURE

HINT:
  1. Refer to the inspection procedure for the CAN communication system.
  2. If the CAN communication malfunctions, the TCM cannot receive current data from the ECM. In this case, the freeze frame data output from the TCM has not been updated so the data will not be useful for the inspection. However, reading the Data List as the first step in troubleshooting is an effective way to find malfunctions.
  3. The malfunctioning area can be confirmed using the Bus Check function of the GTS (Click here).

1.CHECK HARNESS AND CONNECTOR (ECM - TCM)
  1. Disconnect the E27 ECM connector.

  1. Disconnect the T35 TCM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E27-24 (CAN+) - T35-21 (CAN+)
    Always
    Below 1 Ω
    E27-18 (CAN-) - T35-20 (CAN-)
    Always
    Below 1 Ω
    E27-24 (CAN+) or T35-21 (CAN+) - Body ground or other terminals
    Always
    10 kΩ or higher
    E27-18 (CAN-) or T35-20 (CAN-) - Body ground or other terminals
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK IF DTC OUTPUT RECURS (DTC U0100)
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the GTS on.

  1. Enter the following menus: Powertrain / ECT / Trouble Codes / Clear.

  1. Replace the TCM (Click here).

    HINT:
    Replace the TCM with the TCM of a normally functioning vehicle of the same model.

  1. Start the engine.

  1. Enter the following menus: Powertrain / ECT / Trouble Codes.

  1. Read the DTCs using the GTS.
    Result 
    Result
    Proceed to
    U0100 is output
    A
    DTCs are not output
    B



B
REPLACE TCM (Click here)
A

REPLACE ECM (Click here)