HEIGHT CONTROL SENSOR > INSPECTION |
| 1. INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH |
![]() |
Check the rear height control sensor sub-assembly LH:
| *a | Component without harness connected (Rear Height Control Sensor Sub-assembly LH) |
| *b | Low (-) |
| *c | Normal |
| *d | High (+) |
| *e | Stopper position at lowest vehicle height |
| *f | Stopper position at highest vehicle height |
Connect 3 dry batteries of 1.5 V in series.
Connect the positive (+) end of the batteries to terminal 3 (SHB) of the height control sensor and the negative (-) end of the batteries to terminal 1 (SHG). While slowly moving the sensor link up and down, measure the voltage between terminal 2 (SHRR) and terminal 1 (SHG)
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Sensor Condition | Specified Condition |
| 2 (SHRR) - 1 (SHG) | High (+) | Approx. 4.5 V |
| Normal | Approx. 2.5 V | |
| Low (-) | Approx. 0.5 V |