REAR VIEW MONITOR SYSTEM (for Radio and Display Type) > Display Signal Circuit between Radio and Display Assembly and Television Camera Assembly |

| 1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - REAR TELEVISION CAMERA ASSEMBLY) |
Disconnect the R37 radio and display receiver assembly connector.
Disconnect the T38 rear television camera assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| R37-11 (CA+) - T38-4 (CB+) | Always | Below 1 Ω |
| R37-12 (V+) - T38-2 (CV+) | Always | Below 1 Ω |
| R37-23 (CGND) - T38-3 (CGND) | Always | Below 1 Ω |
| R37-24 (V-) - T38-1 (CV-) | Always | Below 1 Ω |
| R37-11 (CA+) - Body ground | Always | 10 kΩ or higher |
| R37-12 (V+) - Body ground | Always | 10 kΩ or higher |
| R37-23 (CGND) - Body ground | Always | 10 kΩ or higher |
| R37-24 (V-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.INSPECT RADIO AND DISPLAY RECEIVER ASSEMBLY |
![]() |
Disconnect the R37 radio and display receiver assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| R37-23 (CGND) - Body ground | Always | Below 1 Ω |
| R37-24 (V-) - Body ground | Always | Below 1 Ω |
| *a | Component without harness connected (Radio and Display Receiver Assembly) |
|
| ||||
| OK | |
| 3.CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY |
![]() |
Disconnect the T38 rear television camera assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| T38-4 (CB+) - T38-3 (CGND) | Ignition switch ACC | 5.5 to 7.05 V |
| *a | Front view of wire harness connector (to Rear Television Camera Assembly) |
|
| ||||
| OK | |
| 4.CHECK REAR TELEVISION CAMERA ASSEMBLY |
Using an oscilloscope, check the waveform.

| *a | Component with harness connected (Radio and Display Receiver Assembly) | *b | Waveform 1 |
| *c | Waveform 2 | *d | Synchronized Signal |
| *e | Video Waveform | - | - |
| Item | Content |
| Tester Connection | R37-12 (V+) - R37-24 (V-) |
| Tool Setting | 0.2 V/DIV., 50 μs/DIV. |
| Condition |
|
|
| ||||
| OK | ||
| ||