AUDIO AND VISUAL SYSTEM (for Radio and Display Type) > Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter |

| 1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY) |
Disconnect the R21 radio and display receiver assembly connector.
Disconnect the N13 No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| R21-28 (VAL+) - N13-8 (VAL+) | Always | Below 1 Ω |
| R21-26 (VAR+) - N13-7 (VAR+) | ||
| R21-27 (VA-) - N13-9 (VA-) | ||
| R21-11 (AGND) - N13-12 (AGND) | ||
| R21-25 (ADPG) - N13-10 (ADPG) | ||
| R21-28 (VAL+) - Body ground | Always | 10 kΩ or higher |
| R21-26 (VAR+) - Body ground | ||
| R21-27 (VA-) - Body ground | ||
| R21-11 (AGND) - Body ground | ||
| R21-25 (ADPG) - Body ground |
|
| ||||
| OK | ||
| ||