Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › REAR BLOWER CONTROL SWITCH

REAR BLOWER CONTROL SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL COOLER (REAR) SWITCH
  1. Connect the connector.

  1. Attach the 2 claws to install the cooler (rear) switch.



2. INSTALL SWITCH BASE
  1. Connect the connectors.

  1. Attach the 9 claws and guide to install the switch base.



3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
  1. Attach the 3 guides, 2 claws and 3 clips to install the lower instrument panel finish panel.



4. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY


B278068E01
  1. Attach the 2 hinges to install the glove compartment door.
    Text in Illustration 
    *1
    Hinge



    B278069E01
  1. While pushing in the sides of the glove compartment door as indicated by the arrows in the illustration, close the door to engage it to the 2 stoppers.
    Text in Illustration 
    *1
    Stopper



5. INSTALL COOLER CONTROL SWITCH ASSEMBLY
  1. Connect the connector.



    E225319
  1. Attach the 2 clips to install the cooler control switch assembly (rear blower control switch) as shown in the illustration.