REAR BLOWER CONTROL SWITCH > INSPECTION |
| 1. INSPECT COOLER CONTROL SWITCH ASSEMBLY |
![]() |
Measure the resistance of the control switch.
| Tester Connection | Switch Condition | Specified Condition |
| 5 - 4 | LO | Below 1 Ω |
| 5 - 4 5 - 3 | M1 | Below 1 Ω |
| 5 - 4 5 - 2 | M2 | Below 1 Ω |
| 5 - 4 5 - 1 | HI | Below 1 Ω |
| 2. INSPECT COOLER(REAR) SWITCH |
![]() |
Measure the resistance of the cooler switch.
| Tester Connection | Switch Condition | Specified Condition |
| 3 - 4 | ON | Below 1 Ω |
| 3 - 4 | OFF | 10 kΩ or higher |
Apply battery voltage to the cooler switch connector and check that the indicator light illuminates.
| Measurement Connection | Switch Condition | Specified Condition |
| Battery positive (+) → Terminal 6 Battery negative (-) → Terminal 3 | ON | Indicator light illuminates |