Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › REAR BLOWER CONTROL SWITCH

REAR BLOWER CONTROL SWITCH > REMOVAL

for Preparation Click here



1. REMOVE COOLER CONTROL SWITCH ASSEMBLY


E225309E01
  1. Using a screwdriver, detach the 2 clips and remove the cooler control switch assembly (rear blower control switch) as shown in the illustration.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape



2. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY


B278058E01
  1. Slightly bend the upper part of the glove compartment door to release the 2 stoppers and open the glove compartment door until it is horizontal.
    Text in Illustration 
    *1
    Stopper



    B278059E01
  1. Pull the glove compartment door toward the rear of the vehicle to detach the 2 hinges and remove the glove compartment door.
    Text in Illustration 
    *1
    Hinge



3. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY


B278242
  1. Detach the 2 claws, 3 clips and 3 guides and remove the lower instrument panel finish panel.



4. REMOVE SWITCH BASE


B278245
  1. Detach the 9 claws and guide.

    HINT:
    If the claws are difficult to detach, detach the claws from the back of the switch base.

  1. Disconnect the connectors and remove the switch base.



5. REMOVE COOLER (REAR) SWITCH


E225604
  1. Detach the 2 claws and remove the cooler (rear) switch.

  1. Disconnect the connector.