LIGHTING SYSTEM > INITIALIZATION |
| HEIGHT CONTROL SENSOR SIGNAL INITIALIZATION (for HID Headlight) |
| 1.PREPARE VEHICLE FOR INITIALIZATION |
Unload the trunk and vehicle, and make sure that the spare tire, tools and jack are in their original positions.
Check that there are no occupants in the vehicle.
Turn off the headlights.
Stop the vehicle on a level surface and keep the vehicle height unchanged.
| |||||
| 2.CHECK WARNING LIGHT |
Turn the ignition switch to ON and check the headlight beam level control system warning light.
| Condition | Specified Condition |
| The headlight leveling ECU is replaced with a new one. | Warning light continuously blinks 6 times at 2 Hz. |
| Removal and reinstallation of the headlight leveling ECU, replacement of the rear height control sensor, removal and reinstallation of the rear height control sensor, replacement of the suspension, etc. | Warning light comes on for approximately 3 seconds, and then turns off (bulb check function). |
|
| ||||
| |||||
| 3.INITIALIZATION |
![]() |
Connect terminals 4 (CG) and 8 (LVL) of the DLC3 using SST.
| *a | Front view of DLC3 |
![]() |
Turn the low beam headlights on and off using the light control switch within 20 seconds after connecting the terminals.
| Fuel Level | Number of Times to Turn Low Beam Headlights on and off |
| Fuel level is within range A. | 1 |
| Fuel level is within range B. | 2 |
| Fuel level is within range C. | 3 |
| Fuel level is within range D. | 4 |
| Fuel level is within range E. | 5 |
Check the warning light.
| Condition | Specified Condition |
| The headlight leveling ECU is replaced with a new one. | Blinks 6 times at 2 Hz → Blinks N* times at 2 Hz, and then turns off. |
| Removal and reinstallation of the headlight leveling ECU, replacement of the rear height control sensor, removal and reinstallation of the rear height control sensor, replacement of the suspension, etc. | Off → Blinks N* times at 2 Hz, and then turns off. |
|
| ||||
|
| ||||
|---|---|---|---|---|---|